Set the temperature Swiftlet House

Set the temperature Swiftlet House

know that the temperature inside the building is ideally 27-29 ° C under these conditions greatly affect the development of the population and the quality of the nest.Too high temperatures 30-32 ° C will swallow saliva dries quickly especially if the humidity is low and consequently porous crack den. Eggs produced is also less good / infertile population growth does not lead to a more severe swiftlet houses could ditinlgal away by a bird's nest. Similarly, if otherwise.That is why handling room temperature should be taken seriously. In order to be stable temperature dikisaran 27-29 ° C can be done with the following steps:

1. Creating VentilationFor the average local temperature heat - approximately 30 - 32 ° C, the vents can use 4 inch pipe size pralon. If the room height between 3-4 feet then plaron pipe needs to be installed with the distance of each - each 1 meter.Installation should be done two rows of the upper section with a distance of 60 cm from the ceiling or deck while the bottom row of pipes are also within 60 cm from the floor.plumbing pipes must be equipped degan Kni mounted on the inside of the building it is useful to reduce the intensity of light and strong winds.

2. Paint the wall / outer wallPainting aims to reduce the intensity of the absorption of the sun's heat to warm temperate regions average - approximately 30 - 32 ° C is not recommended to paint the walls with black except the entrance of birds.Because black is very absorbing heat. But it suggested a light-colored paint. But black enough help to cool temperate regions 24-25 ° C.

3. The strengthening of the wall / wallsThe walls are thick cast will be very helpful because the heat is not too quick to absorb into the building. Bricks are arranged longitudinally has a thickness of 25-30 cm proved sufficient to stabilize at room temperature.Kalimantan region many swiftlet farmers to build houses with stucco walls inside added Styrofoam with a thickness of 5 cm.So that the wall thickness can reach ± ​​10 cm, it is enough to help reduce costs in addition to cheap also more easily obtained.4. Creating artificial rainArtificial rain can be done by installing a sprayer that is connected to the pipe and mounted on the roof. At the scorching sun at about 11 - 12 noon sprayer can be turned on, so the room temperature back down.